Textured Melamine Panels
4/10/18
Website: http://www.TGCabinets.com
I'm in the planning phase for a kitchen with textured melamine doors and end panels. We're going to be using Luxe by Alvic (Frape 003). The architect is asking for a few panels that will be 1.5" thick. I can lay up the materials but am having trouble locating matching banding that is greater than 22mm wide. Any help would be appreciated. Thank you.
4/11/18 #3: Textured Melamine Panels ...
Website: silvawoodworking.com
Can you get the just the Veneer?
4/11/18 #4: Textured Melamine Panels ...
Unfortunately, we had a similar problem a couple of years ago. I had to tell the builder what we could and could not do with Luxe. You cannot miter fold it according to my rep. You can through cut the miters but you would have to carefully deal with the sharp edges so as not to distract from the finish (careful sanding and buffing).
4/12/18 #5: Textured Melamine Panels ...
Website: http://morantzcabinets.com
I buy these panels from Liohor in Miami and they have wide banding that is 1 5/8” wide. I can buy it by the foot. Use it for lining dishwasher openings with two layers or integrated fridge installs where cabinets on either side are visible when doors are open. Harold.
4/19/18 #6: Textured Melamine Panels ...
Website: http://www.centrestreetmillwork.com
Here you go friend:
https://www.richelieu.com/ca/en/category/surfaces-panels-and-edgebandin
g/edgebanding/abs-acrylic-and-pvc-edgebanding/abs-edgebanding-brillante/edgebandi
ng-brillante-627-roble-frape/1191762/sku-G627A0143205
This is 43mm tape for that panel.