Question
Are small log systems profitable? I was studying log optimizers and found a company that sells small log processing systems, handling logs 3"-9" in diameter. If you could run small oak, maple, and cherry logs through it, you could produce flooring and trim. But how would you buy the logs, by the ton or board foot? My guess is by the ton. If you could buy oak, maple, cherry, etc. for around $30 a ton, then it could be profitable.
Forum Responses
(Sawing and Drying Forum)
From Gene Wengert, forum technical advisor:
A small log will be mostly sapwood. Is that okay?
A small log will be quite knotty (low grade lumber). Is that okay?
The center of a log has a lot of stress (non-flat lumber). Is that okay?
The handling cost is high per BF of lumber produced and the footage per saw cut is low compared to larger logs. This means that your lumber is more expensive to produce than lumber from larger logs. Only about 45% of a small log (or less) is converted to lumber. This means lots of waste. Small logs can be profitably sawn into pallet lumber if highly automated and the mill is well designed. Usually, a fairly high production rate is required. Remember that the pulp mills will not run out of logs, so you need to get logs that they are not competing for. Low log costs will be key.
If you had a small log system set up in an area that is relatively flat, then forwarders and skidders with grapples could get to the small timber. Another helpful factor would be government supported thinning of small trees, and yes, the competition would be tough against the big pulp mills. The bigger trees are generally more profitable, so a small log system could be an added value to a bigger mill where all of the factors favoring the small log system are met.
